Furthermore, the users can acquire real data off of their myDAQ devices and compare it to their simulated ones. The template allows you to draw wires connecting your captured schematic with the lines on the virtual myDAQ device, the same way you would connect your breadboard circuit to the actual myDAQ device.Īlso, Multisim integrates NI Elvismx instrumentation within this template, allowing the users to simulate their schematic capture using familiar interfaces. These will represent the actual panels or slots that are available on myDAQ. The template, once open, will have two connecting slots: the myDAQ right slot and the myDAQ bottom terminals. (Multisim needs to be installed prior to the installation of the DAQmx software) Troubleshooting: If you can’t find the template, reinstall DAQmx.
This can be found in Multisim main toolbar at File>New>NI myDAQ Designįigure 1: Launching the NI myDAQ Design Template You can access myDAQ instrumentation in Multisim by opening the “NI myDAQ Design” template. The exercises also require the use of a breadboard, a capacitor (.1uF), a resistor (1kohm), and wires. The user should have all the components installed in this specific order: LabVIEW, Circuit Design Suite, DAQmx. Also, this document requires the installation of the myDAQ Software Suite. To replicate the exercises in this document, the user needs to have myDAQ plugged in.
